Parse error: syntax error, unexpected '<' in /home/lrbaggsc/public_html/forum/archive/index.php(545) : eval()'d code on line 1
Para DI...Effect Loop Issue [Archive] - LR Baggs forum


View Full Version : Para DI...Effect Loop Issue

01-20-2012, 05:07 AM

My recently bought Para DI worked great until I took off a pedal and had it soon as I put the pedal back on the effects loop was noisy with low volume which got worse when I set my gain and turned up the volume...then it worked fine...then back to not working so well.

When I take the effects loop out of the mix the DI works like it should.

I have a very simple acoustic pedal board consisting of a Boss TU-2, Boss CS-3 (modded), Voodoo Lab Sparkle Drive and a Line6 DL4...simple!

I also use George L's solder-less pedal connectors...

I am currently using a cheap Hosa insert cable?

Any suggestions on what it might be before I go ripping my board apart?



01-20-2012, 05:41 PM
Despite being very meticulous when putting together the George L's solder-less connector wasn't making good contact so I swapped for a new piece of cable and after three attempts it works great...

I've been using them on my boards for the last 4 years with little or no problem until now...

I've heard about people not liking these solder-less DYI connectors for this reason!