Problems with Sitar High Pitch Strings (chikaris) and Para DI
I am using a new McIntyre transducer pickup on a Sitar.
I have been running it through a very old (like 20 years!) DOD 16 Band Graphic EQ into an equally old Fender Princeton Chorus Amp.
The overall sound was good, but the old equipment but the EQ had a small amount of noise and I was hoping to improve the sound with less noise by replacing the old EQ.
The McIntyre recommends use of the Para DI, as does the website I bought the McIntyre from.
One problem I have run into with the Para DI, though is that it get a very loud ugly "crunchy" distortion sound from the "Chikari" strings. These are three high pitched strings used for rhythm on the Sitar.
I tried turning down the treble but it doesn't eliminate the distortion and dulls the main playing string instead. I also tried turning down the gain, but I would pretty much need to turn it off to get rid of the crunchy sounds.
I also tried playing around with the Presence control, since the manual mentions it can be useful to get rid of hissing noises, even though this isn't really a hiss. But that doesn't help with the chikari crunch either.
The manual says that the "notch" control can be used for EQ, so I tried that as well. But I hear no real difference whatever frequency I set it to or whether I boost or cut it.
The crunch is definitely from the Para DI... if I unplug the McIntyre from the Para DI and plug directly into the amp, the "chikari crunch" goes away.
Any ideas what I can do? Or is the Para DI just not capable of handling multiple loud high-pitched notes at the same time?
I am assuming this isn't true, and its just a matter of some combination of controls -- but I just haven't been able to figure it out.