Search:

Type: Posts; User: assemblethelight

Search: Search took 0.01 seconds.

  1. L.R Baggs M1 (Passive): Adjusting the pole pieces, matching with Anthem or iBeam.

    Hey guys,

    I recently purchased a L.R Baggs M1 passive and installed it into my Martin D35. I have to admit, I'm not impressed with the sound I'm receiving when referencing it directly recorded...
  2. Replies
    5
    Views
    1,323

    Thanks. Yeah i played around with the notch and...

    Thanks. Yeah i played around with the notch and figured it had to be a narrow notch. I recorded a strumming session into my DAW using just the straight pickup so that i could pin point what i needed...
  3. Replies
    5
    Views
    1,323

    Does the trim start for 27hz on the volume knob...

    Does the trim start for 27hz on the volume knob side or Bass control side? The unit and manual do not show rather it goes clockwise or counter clockwise. There is no reference markings.

    Also, is...
  4. Replies
    5
    Views
    1,323

    My bad, i was confused. Its not a High Pass...

    My bad, i was confused. Its not a High Pass filter, its a Bass trim.

    Does the "Bass trim" pin point the frequency while the Bass control boost/cut that frequency?
  5. Replies
    4
    Views
    2,347

    Marshall AS100D? I remember using this amp with...

    Marshall AS100D? I remember using this amp with more than one acoustic and i recall never using it again because it sounded like an solid state electric amp. It was not nearly as accurate as the...
  6. Replies
    5
    Views
    1,323

    L.R Baggs Gigpro

    I recently purchased the Gigpro to compliment my JJB sound board transducer and also to give it an active current to boost the gain:

    The Gigpro made the pickup come alive and it sound much fuller....
Results 1 to 6 of 6