Just to clarify, the mic capsule is 3mm from the top. The mic housing adheres directly to the top.
The housing dimensions are what I provided above.
Thank you Caleb,
That was my understanding, I just needed to confirm that the ends of the bracing bars do not muffle the sound picked up by the mic.
I have concerns about accurately placing the various parts and the cable clips through the soundhole of an already built guitar, so I am building a cardboard replica for a dummy run . . . if I have to make special tools I will post details to help other users.
Is it possible to let me know the lengths of the three cables - Preamp to mic, preamp to volume control and preamp to battery clip?
Last edited by DavidN; 05-04-2014 at 11:03 AM.
Reason: Clicked reply too soon!!
I'm impressed with the care you're taking with this install. It's good to have a plan of action.
Here are the measurements you requested, from the opening in the shielding tube to the part at the end of the wire:
Microphone wire is 9.75"
Volume control wire is 16.5"
Battery wire is 21.5"
Thank you for you prompt reply.
I am an amateur luthier, with several electrics, two archtops, two classical guitars and three ukes built. I have installed under-saddle transducers in two guitars.
Because of the smallness of the soundhole in the classical and the fact that the guitar is finished I will get only one chance with each part that has to be stuck inside the body!
I will hopefully benefit from being able to see through the soundport that I have cut into the upper bout on the bass side.
As I said before, if I think any of the methods I use will be of help to others like myself I will post pictures.