Results 1 to 2 of 2

Thread: Para DI...Effect Loop Issue

  1. #1
    Junior Member
    Join Date
    Jul 2011

    Para DI...Effect Loop Issue


    My recently bought Para DI worked great until I took off a pedal and had it soon as I put the pedal back on the effects loop was noisy with low volume which got worse when I set my gain and turned up the volume...then it worked fine...then back to not working so well.

    When I take the effects loop out of the mix the DI works like it should.

    I have a very simple acoustic pedal board consisting of a Boss TU-2, Boss CS-3 (modded), Voodoo Lab Sparkle Drive and a Line6 DL4...simple!

    I also use George L's solder-less pedal connectors...

    I am currently using a cheap Hosa insert cable?

    Any suggestions on what it might be before I go ripping my board apart?



  2. #2
    Junior Member
    Join Date
    Jul 2011

    Problem Solved!

    Despite being very meticulous when putting together the George L's solder-less connector wasn't making good contact so I swapped for a new piece of cable and after three attempts it works great...

    I've been using them on my boards for the last 4 years with little or no problem until now...

    I've heard about people not liking these solder-less DYI connectors for this reason!


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts