Results 1 to 3 of 3

Thread: Adding second source to Element

  1. #1
    Junior Member
    Join Date
    May 2011
    Posts
    8

    Adding second source to Element

    I have a guitar with a K&K installed and it just doesn't cut it. Sounds fine just doesn't have the presence to suit me. Can I install an Element and then solder the K&K to the ring channel? The Element installation guide says not to use a high impedance pickup like the iBeam, but I don't know if the K&K is high impedance. I do have have a stereo preamp to mix two signals. Thanks.

  2. #2
    Hi M1A,

    The K&K is a high impedance signal. What you can encounter, if the two signals travel down a stereo cable inside the same shield, is that the low impedance signal(in this case the preamped Element) will bleed or cross-talk into the lead carrying the high impedance passive piezo. The longer the TRS cable between the guitar and the external mixer, the more bleed there can be. It ultimately means you won't have complete isolation of both signals. You can isolate the Element but, if you're looking for more punch and snap from the strings, it may not be a bad thing to have some Element in the K&K signal.

  3. #3
    Junior Member
    Join Date
    Mar 2012
    Location
    East Tennessee
    Posts
    27
    I've run a K&K through a Para DI with pretty good results.
    MikeW
    "He Who Sings, Prays Twice."

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •